Diagnostic Test

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THE AUTOSTICK SWITCH

AUTOSTICK SWITCH RESISTANCE VALUES (COLUMN SHIFT)

NON SWITCHED STATE	ENABLE	DOWNSHIFT	UPSHIFT
21.5k ohms ±1%	2.64k ohms ±1%	4.05k ohms ±1%	8.10k ohms ±1%

Fig 1: Measuring Resistance Between Autostick Switch MUX Circuit & Autostick Switch MUX Return Circuit While Checking Each Switch Position

Courtesy of CHRYSLER LLC

Turn the ignition off to the lock position.

Disconnect the AutoStick® harness connector.

Measure the resistance between the AutoStick Switch MUX circuit and the AutoStick Switch MUX Return circuit while checking each switch position.

NOTE: Use the above chart to and compare your resistive readings.

Does the AutoStick Switch resistance readings match the above chart?

Yes

Using the schematics as a guide, check the Electronic Shift Module (ESM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the ESM (Steering Column) per the Service Information.
Perform NAG1 TRANSMISSION VERIFICATION TEST .

Replace the AutoStick Switch (Shift Lever) per the Service Information.
Perform NAG1 TRANSMISSION VERIFICATION TEST .