Additional Wiring
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
For complete wiring diagrams, refer to:
SYSTEM WIRING DIAGRAMS for 300.
SYSTEM WIRING DIAGRAMS for Charger.
SYSTEM WIRING DIAGRAMS for Magnum.
The PCM uses a dual port RAM internal to the controller to send the engine speed signal to the Transmission Control System. The calculated engine RPM is compared to a minimum and maximum value. If the PCM interprets this signal to be out of range when the engine is running the code is set. The MIL illuminates after 10 seconds of vehicle operation and the transmission system defaults to limp-in mode.