Diagnostic Test

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

1) VERIFY DTC IS ACTIVE
Turn the ignition on.

With the scan tool, read and record ABS DTCs.

With the scan tool, read and record Environmental Data (EV Data).

With the scan tool, erase ABS DTCs.

Cycle the ignition switch.

With the scan tool, read ABS DTCs.

Does this DTC reset?

Yes
1. Go To 2).
No
1. Using the schematics as a guide, check the Anti-Lock Brakes Module, the BCM, and the TCM pins, terminals, and connectors for corrosion, damage, and terminal push out. Pay particular attention to all Communication circuits.
2. Perform ABS VERIFICATION TEST - VER 1 .
2) CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCs
With the scan tool, read all active DTCs from all CAN C Bus modules.

NOTE: Check for CAN C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.

Does the scan tool display any active DTCs related to the conditions listed above?

Yes
1. Diagnose and repair the DTC(s). Refer to appropriate ELECTRICAL DIAGNOSTICS article.
No
1. Go To 3).
3) CHECK IF TCM DTCs ARE PRESENT
With the scan tool, read TCM DTCs.

Are any TCM DTCs present?

Yes
1. Diagnose and repair the DTC(s).
2. Perform appropriate TRANSMISSION VERIFICATION TEST - VER 1.
3. Perform ABS VERIFICATION TEST - VER 1 .
No
1. Using the schematics as a guide, check the Anti-Lock Brakes Module pins, terminals, and connectors for corrosion, damage, and terminal push out. Pay particular attention to all Communication circuits. If no problems are found, replace the Anti-Lock Brakes Module in accordance with the Service Information.
2. Perform ABS VERIFICATION TEST - VER 1 .