LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Anti-Lock Brake System - Electrical Diagnostics) >> Abs Electrical Diagnostics >> DTC Troubleshooting >> C2205-Steering Angle Sensor Internal >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  CHECK FOR A DTC C2205-STEERING ANGLE SENSOR INTERNAL 
    NOTE: This DTC must be active for the results of this test to be valid.

    Turn the ignition on.

    With the scan tool, read and record DTCs.

    With the scan tool, read and record Freeze Frame information.

    With the scan tool, erase DTCs.

    WARNING: Ensure brake capability is available before road testing.

    Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 10 and 25 km/hr (6 and 15 m.p.h.).

    Park the vehicle.

    With the scan tool, read and record DTCs.

    Does the scan tool display: C2205-STEERING ANGLE SENSOR INTERNAL? 

    Yes 

    1. Replace the Anti-Lock Brakes Module in accordance with the Service Information.
    2. Perform ABS VERIFICATION TEST - VER 1 .

    No 

    1. Refer to ABS INTERMITTENT CONDITION .
    2. Perform ABS VERIFICATION TEST - VER 1 .