LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Anti-Lock Brake System - Electrical Diagnostics) >> Abs Electrical Diagnostics >> DTC Troubleshooting >> C1043-Left Rear Tone Wheel Performance >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  CHECK FOR A DTC C1043-LEFT REAR TONE WHEEL PERFORMANCE 
    NOTE: This DTC must be active for the results of this test to be valid.

    Turn the ignition on.

    With the scan tool, read DTCs.

    Record DTC and Freeze Frame information.

    With the scan tool, erase DTCs.

    Cycle the ignition switch off then on.

    CAUTION: Ensure brake capability is available before road testing.

    Test drive the vehicle in a straight line to 40 Km/h (25 mph).

    NOTE: Vehicle must be driven above 40 km/h (25 m.p.h.) for set conditions to be meet.

    With the scan tool, read DTCs.

    Does the scan tool display: C1043-LEFT REAR TONE WHEEL PERFORMANCE? 

    Yes 

    1. Go To  2).

    No 

    1. Refer to ABS INTERMITTENT CONDITION .
    2. Perform ABS VERIFICATION TEST - VER 1 .
  2. 2)  CHECK THE LEFT REAR TONE WHEEL FOR DAMAGE 
    NOTE: Check the tone wheel teeth for missing teeth, cracks, or looseness. Teeth should be perfectly square, not bent, or nicked.

    Check the Left Rear Tone Wheel for damage.

    Check the Left Rear Tone Wheel for dirt.

    Was the tone wheel dirty? 

    Yes 

    1. Clean tone wheel and sensor. Clear codes and retest.
    2. Perform ABS VERIFICATION TEST - VER 1 .

    No 

    1. Replace the Left Rear Tone Wheel in accordance with the Service Information.
    2. Perform ABS VERIFICATION TEST - VER 1 .