LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Anti-Lock Brake System - Electrical Diagnostics) >> Abs Electrical Diagnostics >> DTC Troubleshooting >> B1D5C-Adjustable Pedal Switch Circuit Stuck Forward >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  DTC IS ACTIVE 
    NOTE: This DTC must be active for the results of this test to be valid.

    Turn the ignition on.

    With the scan tool, select view DTCs. Record all DTC information.

    With the scan tool, clear stored DTCs.

    Cycle the ignition switch off then on.

    Move the Adjustable Pedals Switch forward and rearward several times.

    With the scan tool, select view DTCs.

    Is the status active for this DTC? 

    Yes 

    1. Go To  2).

    No 

    1. Refer to the Adjustable Pedal System intermittent condition test. Refer to APS-INTERMITTENT CONDITION .
  2. 2)  ADJUSTABLE PEDALS SWITCH 

    Disconnect the Adjustable Pedals Sensor harness connector.

    Wait approximately 10 seconds.

    With the scan tool, select view DTCs.

    Does the status remain active for this DTC? 

    Yes 

    1. Go To  3).

    No 

    1. Replace the Adjustable Pedals Switch in accordance with the Service Information.
    2. Perform APS VERIFICATION TEST .
  3. 3)  WIRING HARNESS CONNECTOR/TERMINALS 

    Turn the ignition off.

    Disconnect the Memory Seat Module harness connector.

    Inspect the Adjustable Pedals Sensor and Memory Seat Module wiring harness, connectors and terminals.

    Were any problems found? 

    Yes 

    1. Repair as necessary.
    2. Perform APS VERIFICATION TEST .

    No 

    1. Go To  4).
  4. 4)  (Q102) ADJUSTABLE PEDALS SWITCH FORWARD CIRCUIT SHORT TO GROUND 
    Fig 1: Checking Adjustable Pedals Switch Forward Circuit (Q102) For Short To Ground
    GC0039451Courtesy of DAIMLERCHRYSLER CORP.

    Measure the resistance between ground and the (Q102) Adjustable Pedals Switch Forward circuit.

    Is the resistance below 5.0 ohms? 

    Yes 

    1. Repair the (Q102) Adjustable Pedals Switch Forward circuit for a short to ground.
    2. Perform APS VERIFICATION TEST .

    No 

    1. Go To  5).
  5. 5)  (Q102) ADJUSTABLE PEDALS SWITCH FORWARD CIRCUIT SHORT TO (Q101) ADJUSTABLE PEDALS SWITCH GROUND CIRCUIT 
    Fig 2: Checking Adjustable Pedals Switch Forward Circuit (Q102) For Short To Ground Circuit (Q101)
    GC0039452Courtesy of DAIMLERCHRYSLER CORP.

    Measure the resistance between the (Q102) Adjustable Pedals Switch Forward circuit and the (Q101) Adjustable Pedals Switch Ground circuit.

    Is the resistance below 5.0 ohms? 

    Yes 

    1. Repair the (Q102) Adjustable Pedals Switch Forward circuit for a short to the (Q101) Adjustable Pedals Switch Ground circuit.
    2. Perform APS VERIFICATION TEST .

    No 

    1. Replace the Memory Seat Module in accordance with the Service Information.
    2. Perform APS VERIFICATION TEST .