Diagnostic Test

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

1) DTC IS ACTIVE
Turn the ignition on.

With the scan tool, select view DTCs. Record all DTC information.

With the scan tool, clear stored DTCs.

Cycle the ignition switch off then on.

Move the Adjustable Pedals Switch forward and rearward several times.

With the scan tool, select view DTCs.

Is the status active for this DTC?

Yes
1. Go To 2).
No
1. Refer to the Adjustable Pedal System intermittent condition test. Refer to APS-INTERMITTENT CONDITION .
2) WIRING HARNESS CONNECTOR/TERMINALS
Turn the ignition off.

Disconnect the Memory Seat Module harness connector.

Disconnect the Adjustable Pedals Sensor harness connector.

Inspect the wiring harness, connectors and terminals.

Were any problems found?

Yes
1. Repair as necessary.
2. Perform APS VERIFICATION TEST .
No
1. Go To 3).
3) (G13) ADJUSTABLE PEDALS SENSOR SUPPLY CIRCUIT SHORT TO VOLTAGE

Fig 1: Checking Adjustable Pedals Sensor Supply Circuit For Short To Voltage
Courtesy of DAIMLERCHRYSLER CORP.

Turn the ignition on.

Measure the voltage of the (G13) Adjustable Pedals Sensor Supply circuit and ground at the Memory Seat Module C1 harness connector.

Is there any voltage present?

Yes
1. Repair the (G13) Adjustable Pedals Sensor Supply circuit for a short to voltage.
2. Perform APS VERIFICATION TEST .
No
1. Go To 4).
4) (G14) ADJUSTABLE PEDALS SENSOR SIGNAL CIRCUIT SHORT TO VOLTAGE

Fig 2: Checking Adjustable Pedals Sensor Signal Circuit For Short To Voltage
Courtesy of DAIMLERCHRYSLER CORP.

Measure the voltage of the (G14) Adjustable Pedals Sensor Signal circuit and ground at the Memory Seat Module C1 harness connector.

Is there any voltage present?

Yes
1. Repair the (G14) Adjustable Pedals Sensor Signal circuit for a short to voltage.
2. Perform APS VERIFICATION TEST .
No
1. Go To 5).
5) (G14) ADJUSTABLE PEDALS SENSOR SIGNAL CIRCUIT VOLTAGE

Fig 3: Checking Adjustable Pedals Sensor Signal Circuit Voltage
Courtesy of DAIMLERCHRYSLER CORP.

Turn the ignition off.

Reconnect all connectors.

Measure the voltage of the (G14) Adjustable Pedals Sensor Signal circuit at the Memory Seat Module C1 harness connector.

Is the voltage below 4.0 volts?

Yes
1. Replace and reprogram the Memory Seat Module in accordance with the Service Information.
2. Perform APS VERIFICATION TEST .
No
1. Replace the Adjustable Pedals Sensor in accordance with the Service Information.
2. Perform APS VERIFICATION TEST .