LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 265 (Starting System - Electrical Diagnostics) >> Starting - Electrical Diagnostics >> DTC Troubleshooting >> *Remote Start Inoperative >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1) REMOTE START PARAMETERS NOT MET / FAULTY COMPONENT 

    Refer to the Data Display in the scan tool to view possible causes of the inoperative Remote Start System. 

    Repair 

    1. See table below for possible causes for the inoperative Remote Start System:
    2. ABORT
    3. BATTERY VOLTAGE HIGH
    4. BATTERY VOLTAGE LOW
    5. BRAKE PRESSED
    6. COOLANT TEMPERATURE HIGH
    7. CRANK NO START
    8. DRIVER DOOR AJAR
    9. EXCESSIVE GLOW PLUG TIME (DIESEL ONLY)
    10. FAILED COUNTER REACHED (START)
    11. HAZARD LAMPS (SWITCH PRESSED)
    12. HOOD AJAR
    13. IGNITION IN RUN/START
    14. IGNITION NOT IN LOCK
    15. IGNITION SNA (SIGNAL NOT AVAILABLE FROM OTHER MODULE)
    16. INVALID KEY
    17. KEY IN IGNITION
    18. LEFT REAR DOOR AJAR
    19. LOW RPM SHUTDOWN
    20. MIL ON
    21. NO AUTOMATIC TRANSMISSION
    22. NO HOOD SWITCH (INOPERATIVE)
    23. NORMAL TIME OUT CUSTOMER ACCESS
    24. NORMAL TIME OUT RUN MODE (15 MINUTES)
    25. NOT CONFIGURED
    26. NOT ENABLED
    27. NOT IN PARK OR NEUTRAL
    28. NOT PROGRAMMED
    29. OIL PRESSURE LOW
    30. PANIC MODE (ACTIVATED)
    31. PASSENGER DOOR AJAR
    32. POWER LOSS
    33. RIGHT REAR DOOR AJAR
    34. RKE OFF MESSAGE
    35. RPM TOO HIGH (EXCEEDS 2500)
    36. START COUNTER REACHED
    37. TRUNK/LIFTGATE AJAR
    38. VEHICLE SPEED HIGH
    39. VTA ALARMING

    If all of the previous items checked OK, and the remote starting system will not operate, refer to  REMOTE START INOPERATIVE-ANTENNA   for further information. 

    See DIAGNOSIS AND TESTING .