Plug - Spark - 5.7/6.1L

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Ignition Coil Mounting Bolts - 5.7L/6.1L

Courtesy of CHRYSLER LLC

Disconnect and isolate the negative battery cable.
Unlock electrical connector (1) by pressing on tab while pulling electrical connector from coil.
Remove two coil mounting bolts (3).

Fig 2: Removing/Installing Ignition Coil
Courtesy of CHRYSLER LLC
Carefully pull up coil from cylinder head opening with a slight twisting action. Twisting will help break loose boots (1) from spark plugs.
CAUTION: Prior to removing the spark plugs, use compressed air to remove any accumulated dirt and debris. If dirt and debris enter the engine, this may cause internal engine damage.
Remove spark plug from cylinder head using a quality socket with a rubber or foam insert. Also check condition of ignition coil o-ring and replace as necessary.