LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 262 (Ignition System (Service Information)) >> Ignition System - Service Information >> Plug - Spark >> Description >> Plug - Spark - Platinum

Plug - Spark - Platinum

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

The V6 engines use platinum resistor spark plugs. They have resistance values of 3,500 to 20,000 ohms when checked with at least a 1000 volt tester. For spark plug identification and specifications, refer to the SPECIFICATIONS .

Do not use an ohm meter to check the resistance of the spark plugs. This will give an inaccurate reading. 

When the spark plugs use a single or double platinum tips and they have a recommended service life of 100,000 miles for normal driving conditions per schedule A. The spark plugs have a recommended service life of 75,000 miles for severe driving conditions per schedule B. A thin platinum pad is welded to both or just the center electrode end(s). Extreme care must be used to prevent spark plug cross threading, incorrect gapping and ceramic insulator damage during plug removal and installation.

Fig 1: Platinum Pads
GC0015996Courtesy of CHRYSLER LLC
1 - APPLY ANTI-SEIZE COMPOUND HERE ONLY
2 - PLATINUM SPARK SURFACE
CAUTION: Cleaning of the platinum plug may damage the platinum tip.
Fig 2: Setting Spark Plug Electrode Gap
GC0015997Courtesy of CHRYSLER LLC
1 - TAPER GAUGE