LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 261 (Heated Seat System - Rear (Service Information)) >> Heated Seats - Rear - Service Information >> Switch/Module - Rear Heated Seat >> Removal >> Seat Switch

Seat Switch

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Rear Heated Seat Switches
GC0052485Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Using an appropriate flat bladed tool, remove the heated seat switch/modules (5) from the console (2) by gently prying up from the edge of the switch/module bezel (4). Take care not to scratch or damage the console or bezel in any way.
    Fig 2: Heated Seat Switch/Module Bezel
    GC0052492Courtesy of CHRYSLER LLC
  3. Disconnect the switch/module electrical connectors (2) and (4).
  4. Using an appropriate flat bladed tool, remove the heated seat switch/module (3) from the bezel (1).
scientia non olet · About LEMON Manuals