Seat Switch

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Rear Heated Seat Switches

Courtesy of CHRYSLER LLC

Momentary contact push button switch/modules (5) mounted in the rear face of the center console (2) operate the heated rear seat system. Each heated seat switch/module has two Light-Emitting Diode (LED) indicator lamps, which indicate the selected level (Low or High) of the seat heater. Pressing the switch/module button initiates heat. Heat remains on until switched off or until the ignition is turned off. If switched off by the ignition, a switch/module button must be pressed to restart heating.

The switch/modules contain the solid state electronic control and diagnostic logic circuitry for the heated rear seat system. If any of the heated rear seat elements are inoperative or damaged one or more of the LED lamps in the switch/module for the effected seat will flash.

The LED indicator lamps in each heated seat switch/module cannot be repaired. If the LED lamps are inoperative or damaged, or the switch/module is inoperative or damaged the individual heated seat switch/module assembly must be replaced. See REMOVAL for the switch/module replacement procedure.