LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 261 (Heated Seat System - Rear (Service Information)) >> Heated Seats - Rear - Service Information >> Heating Element - Rear Heated Seat >> Removal >> Heated Seat Element

Heated Seat Element

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Heating Element Connectors
GC0052489Courtesy of CHRYSLER LLC
NOTE: Rear seat cushion shown, rear seat back similar.
NOTE: Do not remove the factory installed heating elements (3) from the seat or seat back cushions. The original element is permanently attached and cannot be removed without permanent damage. The replacement heating element is designed to be applied directly on top of the inoperative factory installed heating element.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the appropriate seat cushion cover, refer to REMOVAL , or seat back trim cover, REMOVAL .
  3. Disconnect the inoperative heated rear seat cushion or seat back element electrical connectors (2).
    Fig 2: Rear Heated Seat Heating Elements
    GC0052488Courtesy of CHRYSLER LLC
  4. Locate the wires (1) leading from the inoperative heating element (2) and cut them off flush with the edge of the original heating element.
scientia non olet · About LEMON Manuals