Heated Seats
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Vehicles with the heated rear seat option can be visually identified by the two heated seat switches (5) located in the center floor console (2). The heated seat system allows the rear seat passengers to select from two different levels of electrical seat heating (HI/LO). The heated rear seat system for this vehicle includes the following major components:
- Heated Seat Switch/Module - Two heated seat switch/modules are used per vehicle, including two Light-Emitting Diode (LED) indicator lamps for heat level indication. One switch/module for the left and one for the right rear seats. The switch/modules contain the solid state electronic control and diagnostic logic circuitry for the heated rear seat system. The switch/modules are mounted in the back of the center floor console.
- Heated Seat Elements - Four heated seat elements are used per vehicle, one for each rear seat back and two for the rear seat cushion. The elements are integral to the rear seat cushion and seat back cushion foam and cannot be removed, once installed at the factory.