LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 260 (Heated Seat System - Front (Service Information)) >> Heated Seats - Front - Service Information >> Switch-Heated Seat >> Removal >> Seat Switch

Seat Switch

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Ash Receiver
GC0015941Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the ash receiver (1) from the instrument panel. Refer to REMOVAL .
  3. Disconnect the heated seat switch connector (2) from the heated seat switch (3).
  4. From the back of the ash receiver (1), gently pry the switch (3) free and push the heated seat switch out through the front of the bezel.
scientia non olet · About LEMON Manuals