LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 260 (Heated Seat System - Front (Service Information)) >> Heated Seats - Front - Service Information >> Module-Heated Seats >> Removal >> Module, Heated Seat

Module, Heated Seat

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heated Seat Module
GC0015938Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the right front seat from the vehicle. Refer to REMOVAL .
  3. Reposition the front carpet assembly aside to gain access to the heated seat module (1).
  4. Disconnect the wire harness connector (3) from the heated seat module (1).
  5. Unsnap the heated seat module retaining clips (2) from the floor crossmember.
  6. Remove the heated seat module (1) from the vehicle.
scientia non olet · About LEMON Manuals