LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Starting System (Service Information)) >> Starting - Service Information >> Diagnosis And Testing >> Standard Starting System >> Testing >> Control Circuit Testing

Control Circuit Testing

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

The starter control circuit components should be tested in the order in which they are listed, as follows:

  1. Starter Relay  - Refer to Starter Relay  The starter relay is located within the TIPM (Totally Integrated Power Module). Refer to *INTERMITTENT NO CRANK CONDITION (ETC STARTER INHIBIT) .
  2. Starter Solenoid  - Refer to Starter Motor  in DIAGNOSIS AND TESTING .
  3. Ignition Switch  - Refer to CYLINDER - IGNITION KEY AND LOCK .
  4. Clutch Pedal Position Switch  - If equipped with manual transmission, refer to appropriate transmission article. .
  5. Park/Neutral Position Switch  - If equipped with automatic transmission, refer to Park/Neutral Position Switch  (Transmission Range Sensor) in appropriate Automatic Transmission SERVICE INFORMATION article.
  6. Wire harnesses and connections  - Refer to appropriate SYSTEM WIRING DIAGRAMS article
scientia non olet · About LEMON Manuals