LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 254 (Air Bag Restraint System - Electrical Diagnostics) >> Restraints - Electrical Diagnostics >> DTC Troubleshooting >> B2207-Occupant Restraint Controller Internal 1 >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. REPLACE OCCUPANT RESTRAINT CONTROLLER 

    Turn the ignition on.

    With the scan tool, erase and read ORC DTCs.

    WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.
    WARNING: If the Occupant Restraint Controller is dropped at any time, it must be replaced. Failure to take proper precautions could result in accidental airbag deployment and serious or fatal injury.

    When this code is set, view repair. 

    Repair 

    1. Replace the Occupant Restraint Controller in accordance with the Service Information.
    2. Perform *ORC VERIFICATION TEST - VER 1 .