LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Chime & Buzzer (Service Information)) >> Chime/Buzzer - Service Information >> Module-Park Assist >> Removal >> Module-Park Assist

Module-Park Assist

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Park Assist Module
GC0015714Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Peel back the right inner trunk carpet to expose the Park Assist Module (2).
  3. Remove the two attaching screws (1) and separate the module (2) from the vehicle.
    Fig 2: Removing/Installing Park Assist Module
    GC0015717Courtesy of CHRYSLER LLC
  4. On the wagon, the module will be behind the right side D-pillar trim and is attached the same as the sedan.
    Fig 3: Disconnecting/Connecting Park Assist Module Electrical Connector
    GC0015716Courtesy of CHRYSLER LLC
  5. Disconnect the Park Assist Module (2) electrical connector (1).
scientia non olet · About LEMON Manuals