LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Restraints System (Service Information)) >> Restraints - Service Information >> Air Bag - Seat >> Removal >> Airbag-Seat

Air Bag - Seat: Removal: Airbag-Seat

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the front seat to its most forward position for easiest access to the front seat mounting hardware.
  2. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
  3. Remove the front seat from the vehicle. Refer to REMOVAL .
  4. Remove the trim from the seat back. Refer to REMOVAL .
    Fig 1: Seat Airbag And Trim Cover
    GC0070284Courtesy of CHRYSLER LLC
  5. Pull back the foam (1) from the top and bottom of the air bag trim cover (2) and remove the two fasteners (3) securing the cover to the seat frame.
    Fig 2: Seat Wire Harness Connector
    GC0070285Courtesy of CHRYSLER LLC
  6. Disconnect the seat wire harness connector (1) from the seat airbag inflator.
  7. Remove the one air bag retaining (2) screw from the inboard side of the seat back frame.
    Fig 3: Seat Airbag
    GC0070283Courtesy of CHRYSLER LLC
  8. Slide the air bag (1) from the bottom of its protective cover.
scientia non olet · About LEMON Manuals