Pressure Control Solenoid
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - PRESSURE CONTROL SOLENOID |
| 2 - LINE PRESSURE SENSOR |
| 3 - SHOULDER SCREW |
| 4 - VARIABLE LINE PRESSURE HEADER |
| 5 - MANUAL SHAFT |
| 6 - SCREWS |
- Remove the valve body from the transmission. See REMOVAL .
- Remove the electrical connectors from the pressure control solenoid (1) and the line pressure sensor (2). See Fig 1.
- Remove the screws (6) holding the pressure control solenoid (1) and line pressure sensor (2) to the valve body.
- Remove the pressure control solenoid and line pressure sensor from the valve body.