LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (42RLE Automatic Transmission (Service Information)) >> 42RLE - Service Information >> Mechanism-Brake Transmission Shift Interlock >> Adjustments >> Brake Transmission Shift Interlock Mechanism >> Adjustment Procedure

Adjustment Procedure

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove floor console as necessary for access to the park lock cable. Refer to REMOVAL .
  2. Shift the transmission into the PARK position.
  3. Turn ignition switch to LOCK position. Be sure ignition key cylinder is in the LOCK position. Cable will not adjust correctly in any other position. 
    NOTE: If the key will not turn to the LOCK position, pull up on the cable lock button and manually move the cable in and out until the key can be turned to the LOCK position.
  4. Pull cable lock button up to release cable, if necessary.
  5. Remove and discard the cable adjuster lock pin, if a new cable is being installed.
  6. Ensure that the cable is free to self-adjust by pushing cable rearward and releasing.
  7. Push lock button down until it snaps in place. The lock should be 1-2 mm below the surface of the cylindrical portion of the cable adjustment housing.
scientia non olet · About LEMON Manuals