LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 248 ((HVAC Systems - Electrical Diagnostics)) >> HVAC - Electrical Diagnostics >> DTC Troubleshooting >> *A/C Heater Control Will Not Enter Diagnostic Mode (MTC) >> Additional Wiring

Additional Wiring

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

For complete wiring diagrams refer to:

SYSTEM WIRING DIAGRAMS for 300.

SYSTEM WIRING DIAGRAMS for Charger.

SYSTEM WIRING DIAGRAMS for Magnum.

An active DTC 33 will prevent the control from entering diagnostic mode and performing certain diagnostic functions, it will also prevent proper A/C mode switch and status indicator function. An active DTC 34 will prevent the control from performing certain diagnostic functions and it will prevent proper EBL mode switch and status indicator function. In addition, a short or an open (C41) Blower Switch Position Signal circuit will also prevent the control from entering diagnostic mode. For additional information about the A/C Heater Control's on-board diagnostics, refer to DIAGNOSIS AND TESTING .