LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 246 (Emissions Control System) >> Exhaust Gas RECIRCULATION Valve >> Valve - Exhaust Gas Recirculate >> Installation >> Valve - Exhaust Gas Recirculate - 5.7, 6.1L

Valve - Exhaust Gas Recirculate - 5.7, 6.1L

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying EGR Valve Location
GC0010105Courtesy of CHRYSLER LLC
  1. Position a new metal gasket between cylinder head (1) and valve assembly (3).
  2. Install two mounting bolts (2) and tighten. Refer to SPECIFICATIONS - TORQUE  .
    Fig 2: EGR Tube Bolts
    GC0010106Courtesy of CHRYSLER LLC
  3. Clean EGR tube where it joins EGR valve.
  4. Position new gasket between EGR tube flange and EGR valve assembly.
  5. Install two bolts (3) connecting EGR tube (4) to valve assembly (2). Tighten bolts. Refer to SPECIFICATIONS - TORQUE  .
  6. Connect electrical connector (1) to EGR solenoid (2).
  7. Connect negative battery cable.
  8. Using a diagnostic scan tool, erase any previously recorded DTC's (Diagnostic Trouble Codes).
scientia non olet · About LEMON Manuals