Valve - Positive Crankcase Vent - 5.7L

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: PCV System - 5.7L

Courtesy of CHRYSLER LLC

The PCV valve (3) is mounted into the top/right side of the intake manifold (2).

Fig 2: PCV Valve - 5.7L

Courtesy of CHRYSLER LLC

The PCV valve (1) is sealed to the intake manifold with two O-rings (2).
Remove PCV valve by rotating counter-clockwise 90 degrees until locating tabs (3) have been freed. After tabs have cleared, pull valve straight up from intake manifold.
After valve is removed, check condition of two valve O-rings (2).