Valve - Positive Crankcase Vent - 2.7L

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Air Inlet Hose At Throttle Body

Courtesy of CHRYSLER LLC

The Positive Crankcase Ventilation (PCV) valve is located under the intake manifold on the right bank of the engine.

Loosen the hose clamp (2) from air inlet tube (1). Position the tube (1) away from the throttle body.

Fig 2: PCV Hose Removal
Courtesy of CHRYSLER LLC
Remove the Exhaust Gas Recirculation (EGR) Valve tube, refer to REMOVAL .
Remove the PCV hose (2) from valve (1).

Fig 3: PCV Valve - 2.7L
Courtesy of CHRYSLER LLC

NOTE: The upper intake manifold just needs to be loosened and position aside enough to gain access to the PCV.
Loosen the intake manifold bolts and position the intake manifold aside enough to gain access to the PCV valve. Refer to REMOVAL .
Remove PCV valve (2) from the cylinder cover (1).