LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (6.1L Engine (Service Information)) >> Manifolds >> Manifold-Intake >> Removal >> Intake Manifold

Intake Manifold

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Engine Covers
GC0040317Courtesy of CHRYSLER LLC
  1. Remove engine covers (1).
  2. Bleed fuel system. Refer to STANDARD PROCEDURE .
  3. Disconnect negative cable from battery.
  4. Remove air inlet hose.
  5. Disconnect electrical connectors for the following components:
    1. Manifold Absolute Pressure (MAP) Sensor
    2. Fuel Injectors
    3. ETC ( Electric Throttle Control )
  6. Disconnect brake booster hose, purge hose, and MUA hose ( Make Up Air Hose ).
  7. Remove intake manifold retaining fasteners in a crisscross pattern starting from the outside bolts and ending at the middle bolts.
  8. Remove intake manifold as an assembly.
scientia non olet · About LEMON Manuals