LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (6.1L Engine (Service Information)) >> Manifolds >> Manifold-Intake >> Installation >> Intake Manifold

Intake Manifold

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Engine Covers
GC0040317Courtesy of CHRYSLER LLC
  1. Position intake manifold.
  2. Install intake manifold retaining bolts, and tighten in sequence from the middle bolts towards the outside in a crisscross pattern. Torque fasteners to 124 N.m (124 in. lbs.).
  3. Connect electrical connectors for the following components:
    1. Manifold Absolute Pressure (MAP) Sensor
    2. Fuel Injectors
    3. ETC ( Electronic Throttle Control )
  4. Connect Brake booster hose, purge hose, and MUA hose ( Make Up Air hose ).
  5. Install air inlet hose.
  6. Connect negative cable to battery.
  7. Install engine covers (1).
scientia non olet · About LEMON Manuals