LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (6.1L Engine (Service Information)) >> Lubrication >> Jet-Piston Oil Cooler >> Removal >> Piston Oil Cooler Jet

Piston Oil Cooler Jet

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Oil Pan Torque Sequence
GC0047299Courtesy of CHRYSLER LLC
  1. Remove the oil pan and oil pick-up tube. See INSTALLATION .
    NOTE: When the oil pan is removed, a new oil pan gasket/windage tray assembly must be installed. The old gasket cannot be reused.
  2. Discard the integral windage tray and gasket.
    Fig 2: Oil Jet Remove Install
    GC0052764Courtesy of CHRYSLER LLC
    NOTE: It may be necessary to rotate the engine crankshaft to access the Piston Oil Cooler Jet retaining bolts.
  3. Remove the Piston Oil Cooler Jet retaining bolt (2).
  4. Remove the Piston Oil Cooler Jet (1).
scientia non olet · About LEMON Manuals