LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (6.1L Engine (Service Information)) >> Engine Block >> Tappets-Hydraulic Roller >> Installation >> Hydraulic Roller Tappets

Hydraulic Roller Tappets

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate tappets.
    Fig 1: HYDRAULIC ROLLER TAPPET R+I
    GC0040424Courtesy of CHRYSLER LLC
    1 - TAPPET RETAINER
    2 - HYDRAULIC ROLLER TAPPET
  2. Install tappets in their original positions.
  3. Install tappet guide yoke. Install the tappet guide yoke bolt and tighten to 12 N.m (106 in. lbs.).
  4. Install cylinder head. See INSTALLATION .
  5. Install the push rods and rocker arm assembly. See INSTALLATION .
  6. Install the cylinder head covers. See INSTALLATION .
  7. Install the intake manifold. See INSTALLATION .
  8. Install the air cleaner.
  9. Connect the negative cable to the battery.
    CAUTION: To prevent damage to valve mechanism, engine must not be run above fast idle until all hydraulic tappets have filled with oil and have become quiet.
  10. Road test vehicle and check for leaks.
scientia non olet · About LEMON Manuals