Crankshaft Oil Seal - Rear
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - Special Tool 8349 and C-4171 handle |
| 2 - Seal Guide |
| 3 - Seal |
CAUTION:
The rear seal must be installed dry for proper operation. Do not lubricate the seal lip or outer edge.
- Position the plastic seal guide (2) onto the crankshaft rear face. Then position the crankshaft rear oil seal (3) onto the guide.
- Use Seal Installer 8349 (1) and Driver Handle C-4171, with a hammer, tap the seal (3) into place. Continue to tap on the driver handle until the seal installer seats against the cylinder block crankshaft bore.
- Install the flexplate. See INSTALLATION .
- Install the transmission.