LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (6.1L Engine (Service Information)) >> Engine Block >> Seal-Crankshaft Oil-Front >> Installation >> Crankshaft Oil Seal - Front

Crankshaft Oil Seal - Front

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: FRONT SEAL INSTALLATION
GC0040416Courtesy of CHRYSLER LLC
CAUTION: The front crankshaft seal must be installed dry. Do not apply lubricant to sealing lip or to outer edge.
  1. Use Seal Installer 8348 and Damper Installer 8512A to install the crankshaft front oil seal.
    CAUTION: To prevent severe damage to the Crankshaft or Damper, thoroughly clean the damper bore and the crankshaft nose before installing Damper.
  2. Install vibration damper. See INSTALLATION .
  3. Install radiator cooling fan and shroud. Refer to INSTALLATION .
  4. Install upper radiator hose.
  5. Install accessory drive belt refer. Refer to INSTALLATION .
  6. Refill cooling system. Refer to STANDARD PROCEDURE .
  7. Connect negative cable to battery.
scientia non olet · About LEMON Manuals