LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (6.1L Engine (Service Information)) >> Engine Block >> Retainer-Crankshaft Rear Oil-Seal >> Installation >> Crankshaft Rear Seal Retainer

Crankshaft Rear Seal Retainer

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: REAR SEAL RETAINER TORQUE SEQUENCE
GC0040420Courtesy of CHRYSLER LLC
  1. Thoroughly clean all gasket residue from the engine block.
  2. Use extreme care and clean all gasket residue from the retainer.
  3. Position the gasket onto the retainer.
  4. Position the retainer onto the engine block.
  5. Install the retainer mounting bolts. Tighten the bolts to 15 N.m (132 ft. lbs.) using the procedure shown in illustration.
  6. Install the oil pan. See INSTALLATION .
  7. Install the flexplate. See INSTALLATION .
  8. Install the transmission. Refer to INSTALLATION .
  9. Check and verify engine oil level.
  10. Start engine and check for leaks.
scientia non olet · About LEMON Manuals