LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 244 (6.1L Engine (Service Information)) >> Cylinder Head >> Rods-Rocker Arms And Push >> Removal >> Rocker Arms And Push Rods

Rocker Arms And Push Rods

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cylinder Head Cover Torque Sequence
GC0038690Courtesy of CHRYSLER LLC
  1. Remove cylinder head cover. See REMOVAL .
    Fig 2: Pushrod Retaining Plate
    GC0040356Courtesy of CHRYSLER LLC
  2. Install Push Rod Retaining Plate 9070 (1).
    Fig 3: Rocker Shaft Torque Sequence
    GC0040357Courtesy of CHRYSLER LLC
  3. Loosen the rocker shafts using the sequence provided.
    CAUTION: The rocker shaft assemblies are not interchangeable between intake and exhaust. The intake rocker arms are marked with an "I".
  4. Remove the rocker shafts. Note location for reassembly.
    CAUTION: The longer push rods are for the exhaust side, and the shorter push rods are for intake side.
  5. Remove the push rods. Note push rod location for reassembly.
Fig 4: Rocker Arm Retainer R+I
GC0040358Courtesy of CHRYSLER LLC
1 - ASSEMBLY TANG
2 - RETAINER ( FULLY SEATED )
3 - SPACER
4 - ROCKER ARM
CAUTION: Do not remove the retainers from the rocker shaft. The assembly tangs (1) at the bottom of the retainers (2) can be damaged, causing the assembly tangs to break off, and get into the engine.
scientia non olet · About LEMON Manuals