LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 243 (5.7L Engine (Service Information)) >> Manifolds >> Manifold - Exhaust >> Removal >> Exhaust Manifolds >> Exhaust Manifold

Exhaust Manifold

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Hydromount LH
GC0015463Courtesy of CHRYSLER LLC
1 - Bolt
2 - Hydromount
3 - Studs
Fig 2: Engine Hydromount RH
GC0015462Courtesy of CHRYSLER LLC
1 - Studs
2 - Nut
3 - Hydromount
4 - Studs
  1. Disconnect negative battery cable.
  2. Raise vehicle.
  3. Remove exhaust pipe to manifold bolts.
  4. Remove engine mount to frame fasteners (3,4).
  5. Using suitable jack, raise engine enough to remove manifolds.
    CAUTION: Do not damage engine harness while raising the engine.
  6. Remove the engine mount. See REMOVAL .
    Fig 3: Exhaust Manifold Bolt Tightening Sequence - Left
    GC0004014Courtesy of CHRYSLER LLC
    Fig 4: Exhaust Manifold Bolt Tightening Sequence - Right
    GC0004013Courtesy of CHRYSLER LLC
  7. Remove heat shield.
  8. Remove manifold bolts using sequence provided.
  9. Remove manifold and gasket.
scientia non olet · About LEMON Manuals