LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 243 (5.7L Engine (Service Information)) >> Engine Block >> Tappets-Hydraulic Roller >> Removal >> Removal

Tappets-Hydraulic Roller: Removal: Removal

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative cable from the battery.
  2. Remove the air cleaner Refer to SYSTEM-AIR INTAKE .
  3. Remove intake manifold. See REMOVAL .
  4. Remove cylinder head cover. See REMOVAL .
  5. Remove rocker arm assembly and push rods. See REMOVAL . Identify push rods to ensure installation in original location.
  6. Remove the cylinder head. See REMOVAL .
    Fig 1: Remove/Install Hydraulic Roller Tappet
    GC0003965Courtesy of CHRYSLER LLC
    1 - TAPPET RETAINER
    2 - HYDRAULIC ROLLER TAPPET
  7. Remove bolt from tappet guide holder.
  8. Remove tappet guide holder.
  9. Pull tappet out of bore with a twisting motion. If all tappets are to be removed and reused, identify tappets to ensure installation in original location. 
  10. Check camshaft lobes for abnormal wear.
scientia non olet · About LEMON Manuals