LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 243 (5.7L Engine (Service Information)) >> Engine Block >> Solenoid-MDS >> Installation >> MDS Solenoid

MDS Solenoid

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: MDS SOLENOIDS
GC0051334Courtesy of CHRYSLER LLC
  1. Verify that MDS bores are free of debris, before solenoid installation.
  2. Install MDS solenoid(s) (3) fully into block.
  3. Install hold down bolt (2) and tighten to 11 N.m (97 in. lbs.).
  4. Reconnect the MDS wiring harness to the solenoid(s) (3).
  5. Install foam insulator pad (1) if removed.
  6. Install the intake manifold. See INSTALLATION .
scientia non olet · About LEMON Manuals