Crankshaft Oil Seal - Front

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Seal Installation

Courtesy of CHRYSLER LLC

1 - SPECIAL TOOL 8512A INSTALLER

2 - SPECIAL TOOL 9072 INSTALLER

CAUTION: The front crankshaft seal must be installed dry. Do not apply lubricant to sealing lip or to outer edge.

Using Crankshaft Front Oil Seal Installer 9072 (2) and Damper Installer 8512A (1), install crankshaft front seal.
CAUTION: To prevent severe damage to the Crankshaft or Damper, thoroughly clean the damper bore and the crankshaft nose before installing Damper.
Install vibration damper. See INSTALLATION .
Install radiator cooling fan and shroud. Refer to INSTALLATION .
Install upper radiator hose.
Install accessory drive belt refer. Refer to INSTALLATION .
Refill cooling system. Refer to STANDARD PROCEDURE .
Connect negative cable to battery.