LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (3.5L Engine (Service Information)) >> Manifolds >> Manifold - Intake >> Removal >> Intake Manifold-Lower

Intake Manifold-Lower

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Lower Intake Manifold
GC0001970Courtesy of CHRYSLER LLC
1 - LOWER INTAKE MANIFOLD
2 - GASKET
  1. Perform fuel pressure release procedure. Refer to STANDARD PROCEDURE .
  2. Drain the cooling system.
  3. Disconnect the upper radiator hose from the thermostat housing.
  4. Remove the upper intake manifold. See REMOVAL .
  5. Reposition power steering fluid reservoir and bracket.
  6. Disconnect the electrical connectors to fuel injectors and coolant temperature sensor.
    Fig 2: Coolant Pipe
    GC0015399Courtesy of CHRYSLER LLC
    1 - COOLANT PIPE
    2 - HEATER HOSE
    3 - COOLANT RESERVOIR HOSE
  7. Disconnect heater hose from the rear intake manifold. See Fig 2.
  8. Disconnect the coolant container hose at the rear intake manifold. See Fig 2.
    Fig 3: Fuel Rail & Lower Intake Manifold
    GC0015453Courtesy of CHRYSLER LLC
    1 - FUEL RAIL
    2 - IGNITION COIL
    3 - LOWER INTAKE MANIFOLD
    4 - PCV VALVE
  9. Disconnect the fuel supply hose from fuel rail. Refer to STANDARD PROCEDURE .
  10. Remove the bolts attaching fuel rail.
  11. Remove fuel rail and injectors as an assembly.
  12. Remove bolts attaching lower intake and remove intake manifold. See Fig 1.
scientia non olet · About LEMON Manuals