Pump - Oil: Installation: Pump-Oil
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - CRANKSHAFT |
| 2 - DOWEL |
| 3 - GASKET |
| 4 - OIL PUMP |
| 5 - FRONT CRANKSHAFT SEAL |
| 6 - CRANKSHAFT GEAR |
| 7 - PIN |
- Prime oil pump (4) before installation by filling rotor cavity with clean engine oil.
- Install oil pump (4) and gasket (3) carefully over the crankshaft. Position pump onto block and tighten bolts to 28 N.m (250 in. lbs.).
1 - OIL PICK UP TUBE WITH STRAINER 2 - BOLT 3 - O-RING 4 - OIL PUMP 5 - WINDAGE TRAY - Install new O-ring (3) on oil pickup tube (1).
- Install oil pickup tube (1).
- Install oil pan. See INSTALLATION .
- Install crankshaft sprocket. See INSTALLATION .
- Install timing belt. See INSTALLATION .
- Install the timing belt covers. See INSTALLATION .
1 - DRIVE BELT TENSIONER 2 - POWER STEERING PULLEY 3 - AIR CONDITIONING COMPRESSOR 4 - CRANKSHAFT DAMPER 5 - GENERATOR 6 - DRIVE BELT - Install the crankshaft vibration damper (4). See INSTALLATION .
- Install the accessory drive belt (6). See Fig 3. Refer to INSTALLATION .
- Fill the cooling system. Refer to STANDARD PROCEDURE .
- Fill engine crankcase with proper oil to the correct level.