Mount -Left: Removal: Mount-Left

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Left Engine Mount Heat Shield

Courtesy of CHRYSLER LLC

1 - LEFT ENGINE MOUNT

2 - HEAT SHIELD

3 - BOLT

Disconnect the negative battery cable.
Raise and support the vehicle.
Remove both engine mount to cradle nuts and remove the left engine mount studs.
Using a suitable jack and a block of wood under the oil pan, raise the engine until the weight is off of the mounts (approximately 5 mm).
Remove the engine mount heat shield. See Fig 1.

Fig 2: Left Engine Mount
Courtesy of CHRYSLER LLC

1 - ENGINE MOUNT

2 - BOLT
Remove the engine mount bolts and remove the mount. See Fig 2.