LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (3.5L Engine (Service Information)) >> Engine Mounting >> Mount - Right >> Removal >> Engine Mount - Right

Engine Mount - Right

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Right Engine Mount Heat Shield
GC0015432Courtesy of CHRYSLER LLC
1 - BOLT
2 - SHIELD
3 - RIGHT ENGINE MOUNT
  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle.
  3. Remove both of the engine mount to cradle nuts.
  4. Remove both of the engine mount through studs.
  5. Using a suitable jack stand and a block of wood positioned under the oil pan, raise the engine until the weight is off of the mounts (approximately 5 mm.).
  6. Remove the right mount heat shield (2) bolts. See Fig 1.
    Fig 2: Right Engine Mount
    GC0015431Courtesy of CHRYSLER LLC
    1 - BOLT
    2 - RIGHT ENGINE MOUNT
  7. Remove the engine mount (2). See Fig 2.
scientia non olet · About LEMON Manuals