LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (3.5L Engine (Service Information)) >> Cylinder Head(S) >> Spring -Valve >> Installation >> Spring -Valve - Cylinder Head On

Spring -Valve - Cylinder Head On

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Valve Spring
GC0001871Courtesy of CHRYSLER LLC
1 - MD 998772A
2 - SPARK PLUG TUBES
3 - CYLINDER HEAD
4 - 6527 - Adapter
5 - VALVE SPRING RETAINER
  1. Install new valve seal(s) if required. See INSTALLATION .
  2. Place valve spring (color-coded end facing up) and valve retainer into position.
  3. Compress valve spring using Special Tool MD 998772A (1) with Adapter 6527 (4) only enough to install locks (5). See Fig 1.
  4. After installing locks, release tension on valve spring and verify proper installation.
  5. Remove Special Tool MD 998772A (1) and spark plug adapter tool.
  6. Install rocker arm and shaft assembly. See INSTALLATION .
  7. Install cylinder head cover(s). See INSTALLATION .
  8. Install spark plugs.
  9. Install upper intake manifold. See INSTALLATION .
  10. Connect negative battery cable.
scientia non olet · About LEMON Manuals