Shaft -Rocker Arms
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - HYDRAULIC LASH ADJUSTERS |
| 2 - DOWEL PIN |
| 3 - PEDESTAL |
| 4 - ROLLER |
CAUTION:
New dowel pins must be installed when reassembling.
- Install the rocker arms, and pedestals (3) onto the shaft.
- Install dowel pins (2). See Fig 1. Dowel pins (2) pass through the pedestal (3) into the exhaust rocker shafts. Dowel pins (2) should be pressed in until they bottom-out against the rocker shaft in the pedestal (3).
- Install rocker arm and shafts. See INSTALLATION .