Cylinder Head

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Checking Cylinder Head Flatness

Courtesy of CHRYSLER LLC

Before cleaning, check for leaks, damage and cracks.
Clean cylinder head and oil passages.
Check cylinder head for flatness. See Fig 1.
Cylinder head must be flat within:
1. Standard dimension = less than 0.05 mm (0.002 inch.)
2. Service Limit = 0.2 mm (0.008 inch.)
3. Grinding Limit = Maximum of 0.2 mm (0.008 inch.) is permitted.

CAUTION: 0.20 mm (0.008 in.) MAX is a combined total dimension of the stock removal limit from cylinder head and block top surface (Deck) together.