LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (3.5L Engine (Service Information)) >> Cylinder Head(S) >> Cover Cylinder Head - Right >> Removal >> Cylinder Head Cover - Right

Cylinder Head Cover - Right

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Ignition Coils - Right Cylinder Head
GC0015400Courtesy of CHRYSLER LLC
WARNING: DO NOT START OR RUN ENGINE WITH CYLINDER HEAD COVER REMOVED FROM THE ENGINE. DAMAGE OR PERSONAL INJURY MAY OCCUR.
  1. Disconnect the negative battery cable.
  2. Remove the upper intake manifold. See REMOVAL .
  3. Cover lower intake manifold openings during service.
  4. Disconnect and remove the three ignition coils (2).
  5. Lift up on the wire harness track retaining tabs (4).
  6. Remove the ground strap retaining bolt (3) from the cylinder head cover.
  7. Completely loosen the cylinder head cover retaining bolts and remove the cylinder head cover.
scientia non olet · About LEMON Manuals