LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (3.5L Engine (Service Information)) >> Cylinder Head(S) >> Cover Cylinder Head - Right >> Installation >> Cylinder Head Cover - Right

Cylinder Head Cover - Right

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cylinder Head Cover Gasket & Spark Plug Tube Seals
GC0001840Courtesy of CHRYSLER LLC
1 - CYLINDER HEAD COVER GASKET
2 - SPARK PLUG TUBE SEALS
  1. Clean cylinder head and cover mating surfaces. Inspect and replace gasket (1) and seals (2) as necessary. See Fig 1.
    Fig 2: Installing Spark Plug Tube Seal
    GC0001841Courtesy of CHRYSLER LLC
    1 - SPECIAL TOOL MD-998306
    2 - SPARK PLUG TUBE SEAL
  2. To replace spark plug tube seals (2):
    • Using a suitable pry tool, carefully remove tube seals (2).
    • Position new seal (2) with the part number on seal facing cylinder head cover.
    • Install seals using MD-99830 (1). See Fig 2.
    Fig 3: Ignition Coils - Right Cylinder Head
    GC0015400Courtesy of CHRYSLER LLC
  3. Install cylinder head cover bolts and tighten to 12 N.m (105 in. lbs.).
  4. Install the ground strap retaining bolt (3) to the cylinder head cover.
  5. Install the wire harness track (4).
  6. Install the ignition coils (2). Tighten mounting screws to 6.7 N.m (60 in. lbs.). See Fig 3.
  7. Connect the ignition coil electrical connectors (2). See Fig 3.
  8. Install upper intake manifold. See INSTALLATION .
  9. Connect negative battery cable
scientia non olet · About LEMON Manuals