LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (3.5L Engine (Service Information)) >> Cylinder Head(S) >> Cover Cylinder Head - Left >> Removal >> Cylinder Head Cover - Left

Cylinder Head Cover - Left

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Ignition Coils - Left Cylinder Head
GC0015401Courtesy of CHRYSLER LLC
WARNING: DO NOT START OR RUN ENGINE WITH CYLINDER HEAD COVER REMOVED FROM THE ENGINE. DAMAGE OR PERSONAL INJURY MAY OCCUR.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the upper intake manifold from the engine. See REMOVAL .
  3. Cover lower intake manifold (4) with a suitable cover during service.
  4. Disconnect and remove the three ignition coils (2). See Fig 1.
  5. Remove the ground strap/resistor retaining bolt from the cylinder head cover.
  6. Lift up on the wire harness track (3) retaining tabs. See Fig 1.
    Fig 2: Cylinder Head Covers
    GC0001832Courtesy of CHRYSLER LLC
    1 - CYLINDER HEAD COVER-LEFT SIDE
    2 - BOLTS (8)
  7. Completely loosen the cylinder head cover retaining bolts and remove the cylinder head cover. See Fig 2.
scientia non olet · About LEMON Manuals