LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 242 (3.5L Engine (Service Information)) >> Cylinder Head(S) >> Cover Cylinder Head - Left >> Installation >> Cylinder Head Cover - Left

Cylinder Head Cover - Left

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cylinder Head Cover Gasket & Spark Plug Tube Seals
GC0001837Courtesy of CHRYSLER LLC
1 - CYLINDER HEAD COVER GASKET
2 - SPARK PLUG TUBE SEALS
  1. Clean cylinder head and cover mating surfaces. Inspect and replace gasket (1) and seals (2) as necessary. See Fig 1.
    Fig 2: Installing Spark Plug Tube Seal
    GC0001836Courtesy of CHRYSLER LLC
    1 - SPECIAL TOOL MD-998306
    2 - SPARK PLUG TUBE SEAL
  2. To replace spark plug tube seals (2):
    • Using a suitable pry tool, carefully remove tube seals (2).
    • Position new seal (2) with the part number on seal facing cylinder head cover.
    • Install seals using MD-998306 (1). See Fig 2.
    Fig 3: Cylinder Head Covers
    GC0001832Courtesy of CHRYSLER LLC
    1 - CYLINDER HEAD COVER-LEFT SIDE
    2 - BOLTS (8)
  3. Install cylinder head cover (1) and bolts (2). Tighten to 12 N.m (105 in. lbs.).
    Fig 4: Ignition Coils - Left Cylinder Head
    GC0015401Courtesy of CHRYSLER LLC
  4. Position the wiring harness (3) on the cylinder head cover.
  5. Reclip the wire harness track retaining tabs into the cover.
  6. Install the ground strap/resistor retaining bolt onto the cylinder head cover.
  7. Install the ignition coils (2). Tighten mounting screws to 6.7 N.m (60 in. lbs.)
  8. Connect the ignition coil electrical connectors (2).
  9. Install upper intake manifold. See INSTALLATION .
  10. Connect negative battery cable.
scientia non olet · About LEMON Manuals