Cylinder Head(S): Camshaft(S): Installation: Camshaft
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - SPARK PLUG TUBE |
| 2 - ROCKER ARM ASSEMBLY |
| 3 - CAMSHAFT |
| 4 - SEAL |
NOTE:
Care must be taken not to scrape or nick the camshaft journals when installing the camshaft into position.
- Lubricate camshaft (3) bearing journals, camshaft lobes and camshaft seal (4) with clean engine oil and install camshaft (3) into cylinder head. See Fig 1.
- Install the cylinder head. See INSTALLATION .